Ask Experts Questions for FREE Help !
Ask
    Woodsville55's Avatar
    Woodsville55 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 29, 2012, 02:46 PM
    Shower not hot enough
    My shower used to run fine, but just recently the temperature when on full power has decreased. It used to run fine when I set the temp gage to around level 3-4 (out of 10) The only way I can now take a shower at a more reasonable temperature is to turn the dial to a much higher temperature 8 - 9 but this has the effect of reducing the pressure. The shower I have is a Triton Amber II.

    Any ideas people?
    T
    drtom4444's Avatar
    drtom4444 Posts: 3,282, Reputation: 145
    Ultra Member
    		  
    #2

    Nov 2, 2012, 09:33 AM
    One of the elements is bad. You will need to take it down and find the bad element. I would just replace both of them. Here is a manual: https://dl.dropbox.com/u/8010163/amber3.pdf
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

I need a replacement for a Jacuzzi Wall Shower valve and Hand held Shower [ 4 Answers ]

I have a really bad hot water leak in my tub/shower. I'm guessing that the Jacuzzi shower tower/tub are about 15 years old. Model # JAC D952000. I'm hoping to just replace the hardware. I had someone look at it today and he puzzled. He also made the leak worse than it was. Does anyone know...

Do we tile all of the shower walls even around the shower pipes then shower handle on [ 4 Answers ]

We are tiling around the tub do we tile all 3 walls then put shower handle and tub spout on walls or do we put tub handle on wall then tile around it?

When I turn my shower on the head makes a load noise during the entire shower? [ 1 Answers ]

When I turn it on the noise begins almost immeditaly afterwards. And the noise only stops when we slow the amount of water coming through the shower head.

Correct pvc shower drain for sterling #62040100 60" seated shower receptor [ 6 Answers ]

Has anyone installed a sterling 60" seated shower receptor with wall surrounds on a concrete slab. The new unit did not come with a shower drain. there is a hole in the bottom That is 3-5/16" (8.4cm) and it calls for a drilled hole in slab oor foundation of 4-1/2" (11.4cm). the old drain line...

My shower drain is raised above the shower pan by 3/16" causing standing water [ 2 Answers ]

I have a fiberglass shower stall where the bottom has either slumped or the stall was installed wrong to begin with (it has no support beneath the surface that I stand on). The drain sticks above the level line so I have about 3/16" of standing water. I cannot easily access the bottom from the...

View more questions Search