Ask Experts Questions for FREE Help !
Ask
    Hunt Stoddard's Avatar
    Hunt Stoddard Posts: 4, Reputation: 1
    New Member
    		  
    #1

    Oct 27, 2012, 09:53 PM
    Timer switch on Maytag washer
    I have a Maytag washer that stops before the spin on the rinse cycle and then I have to move the dial to the extra spin cycle. Is this the timer switch (which is $136) or something less expensive?
    drtom4444's Avatar
    drtom4444 Posts: 3,282, Reputation: 145
    Ultra Member
    		  
    #2

    Oct 28, 2012, 12:01 AM
    It sounds like a bad timer.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

How to remove kenmore washer timer part no: 3356457 from washer model 110.92283100? [ 2 Answers ]

My kenmore washer model 110.92283100 does not advance to next function, it still do the work if I use my hand to turn to the next function. So I thought that my washer timer part number 3356457 is at fault. I have no instruction to remove the timer from its control panel and I do not want to break...

Maytag dryer atlandtis.timer will not advance. Heat works.replaced timer still will [ 1 Answers ]

I have a maytag atlantis. The timer will not advance. The heat works.I replaced the timer still will not move.

How to test Kenmore apartment washer dryer combo timer cycle switch [ 1 Answers ]

Appliance troubleshooting

I have a maytag bravos washer. I have a problem that when my washer is in rinse mode [ 0 Answers ]

I have awasher it's a maytag bravos, it fills with water when on rinse mode but does not kick on to spin mode it shuts off with an error code that reads ol on the screen and makes me start over again.what can I do

Maytag LAT3914AAE timer? [ 1 Answers ]

Hello, I have a Maytag LAT3914AAE and it will not start unless its in the spin or rinse cycle. I am guessing the timer is bad.. if so, what timer should I get, and how do I replace it? Should I even bother doing it myself or call a technician? Thanks for your help.

View more questions Search