Ask Experts Questions for FREE Help !
Ask
    rb123asc's Avatar
    rb123asc Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 23, 2012, 05:31 PM
    Furnace won't start the heater fan
    I have a Concord 80 plus HVAC unit. Model rgc80a100d12-3. Out of the blue the Furnace stopped working. Last year the port on the inducer was plugged. I have cleaned that off and that is not the problem this time. I have about 3 volts on that switch until the inducer starts then the furnace voltage goes to about 15. I have cleaned the flame sensor. Now what happens is the inducer starts then the furnace will click and the glow plug lights. Then the gas valve opens and the burners light. They are all blue and appear to be uniform. The furnace will run like this for up to and over a minute. Well into the time that the fan should come on. The furnace then clicks 2 separate times. Shortly after that the flames go off. The inducer continues to run for about 30 to 45 seconds and shuts off. The furnace will later try to start the process again. I tried turning on the AC and turning the temp down to 60 currently the temp is 62 in the house. The AC Condenser turned on outside and I could hear the fluid rolling through inside the furnace. The fan never came on. If I go to the thermostat and turn the fan "on" instead of "auto" the blower still won't come on. Doing the AC test there were no codes flashing. It was just Dim and Bright flashes. When the heat fails the light will flash 3 times.
    Grady White's Avatar
    Grady White Posts: 1,417, Reputation: 59
    Ultra Member
    		  
    #2

    Oct 24, 2012, 07:03 PM
    It sounds like you have either a bad fan control or fan motor. Does the furnace have a circuit board to which the fan is wired?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

74 chevy truck will turn over but won't start. Will start with starter fluid but won't [ 1 Answers ]

My 74 chevy pickup sat over the winter and now it won't start. I was running just fine before I let it sit. It turns over but won't start. If I use starter fluid, it will start but won't stay running. I don't smell gas in the carb either. I'm thinking it's the fuel pump or the filter. Problem...

my john deere z 425 won't start, it turns over but won't start [ 0 Answers ]

my john deere z 425 won't start, it turns over but won't start. I keep turning it over but it never cranks. It only has 150 hours on it

My bryant furnace 330aav won't start [ 0 Answers ]

I have a bryant 330aav036100 furnace. The LED is solid on not flashing. It will not go on. I tried turning off the power for 5 min. then turned it back on it didn't even go through it's startup. It does nothing. Is this the control board or something else.

Gas Furnace Heater will not start [ 3 Answers ]

The furnace turns on as air is blowing however the gas will not ignite. The problem seems to be with the pilot but the instructions on the furnace only states how to turn off and restart the furnace system. The gas valve switch has an on and off button and the instructions tell to turn it off for...

View more questions Search