Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
3A Fuse on Control Board Keeps Blowing
[ 0 Answers ]
After reading several posts, I checked the 2 wires going outside and found them to be fine. Replaced contacter, still blows fuse. Replaced 2 wires going outside just in case I missed something the first time, still blows fuse. Removed wires from contacter and does NOT blow fuse. What else am I...
Trane control board fuse blowing
[ 6 Answers ]
Help! A/C unit went out last night. Opened inside unit up (Trane XE80) and pulled the 5 amp blade fuse on the control board and saw that it had blown. Replaced the 5 amp fuse, closed the panel, and the blower started. When I went to turn on the A/C, the 5 amp fuse blew again (and again). ...
Ford f250 6.0 psd keeps blowing the engine control fuse
[ 1 Answers ]
Ford f250 6.0 psd keeps blowing the engine control fuse
Keeps blowing 3 Amp Fuse on Control Panel.
[ 1 Answers ]
I Have A Carrier (58gsc)upflow Furnace & A/c Unit, Which Is 18 Years Old. When I Tried To Turn The Heater On , Only Blower Came On & Would Not Turn Off Unless Disconnected From Electricity. Replaced Sofar Control Unit, Thermostat,transformer Was Blown,& Finally The Limit Switch. When I...
Furnace control board fuse keeps blowing
[ 1 Answers ]
Hi, I have a Carrier furnace 48GS-036090311TP with a Honeywell T8401C thermostat. I can run the fan on continuously but when I put the Heat to ON on the T-stat, the 5 Amp fuse on the control board (LH33WP003A) in the furnace blows. The sequence is like this: 1. Fan only operation is running... View more questions Search
|