Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Symmons Temptrol Shower Handle Stuck
[ 21 Answers ]
I have a Symmons Temptrol shower and am trying to replace the diverter (part #TA-25A). I unscrewed the screw in the center of the handle (as well as the other screws on the face plate) and have not beeen able to remove the handle. It appears that it should pull off once the screw is removed but...
Symmons temptrol(?) shower w/Brasscraft Handle
[ 3 Answers ]
Unidentified bathroom fixtures were installed in the house before we moved in several years ago. The shower controller was recently identified as Symmons by one plumbing veteran (possibly a Temptrol based on the blow-up schematics that I have seen). The handle, which matches the other bathroom...
Symmons Temptrol tub and bath faucet leaking
[ 2 Answers ]
I have a Symmons Temptrol tub and bath faucet which is leaking at the handle. It is 20 years old and I suspect that the cartridge needs replacing. Do I remove the handle first and then the plate which is held by two screws? Where is the cartridge located? Is there some literature that will...
Symmons temptrol - no water
[ 2 Answers ]
I'm getting nothing but a dribble on hot and cold, tub or shower settings. Was fine until today. Any way to tell if it is the valve or seat? There's nothing else to replace, right? Thanks
Symmons Temptrol Shower/Tub Handle -
[ 1 Answers ]
I printed off the internet the part breakdwon to my tub/shower one-dial Symmons Temtrol kit as I am trying to stop a slow leak out oif the tub faucet. I removed the screw and cap - and I can't get the handle off - is it hyst suppoosed to pull off once the screw is removed? That is how the... View more questions Search
|