Ask Experts Questions for FREE Help !
Ask
    brainii's Avatar
    brainii Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Sep 27, 2012, 11:27 PM
    No drain
    I got 4 Mitsubishi a/c units all working fine for 6 years.
    My house has pre-drilled points for a/c units, and pre made drainage pipes leading to the outside.
    While the 3 ac's drain through the pipes normally, one of the a/c's doesn't seem to drain anywhere (not through the pipes, not at the compressor outside and it doesn't of course have a separate drain pipe , none of them do, they use the pre-built ones).
    There is no moisture on the walls so WHERE does the condensation drain on the 4th ac?
    Thanks
    Hot Corn Bread's Avatar
    Hot Corn Bread Posts: 70, Reputation: 3
    Junior Member
    		  
    #2

    Sep 28, 2012, 06:40 AM
    Weird! Would seem the drain is clogged inside the case. Water pan could be tall enough to hold considerable condensate and fan is blowing a lot out through the condenser coil. I think poke up that drain a bit and see if you get a response. Otherwise take it out and do a look see inside for what's going on. Maybe it's low gas and not making much water.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Can an Oatey ABS No-caulk shower base drain be used with a copper drain pipe? [ 5 Answers ]

I am replacing a free standing Spartan shower with an inexpensive Swanstone free standing shower. The Swanstone comes with an Oatey ABS drain. My question is: can this plastic drain be used with my copper drain pipe? The pipe is extending up over the cement floor by an inch. I believe that I must...

Remove utility sink and drain new washer and conditioning system in existing drain [ 4 Answers ]

My water conditioning system currently backwashes into a utility sink. I wish to remove the utility sink and hook up both a new washing machine and the water conditioning system to the existing drain (not enough room to keep the utility sink). How can I do this?

Connecting to 1 1/2" copper drain with pvc kitchen sink drain trap [ 8 Answers ]

I'm trying to rehook up the kitchen sink pvc trap to the old copper drain pipe but the connector doesn't fit tight enough and the water links out. Any ideas how to stop this leak?

Ok to tie a wet bar drain into a drain pipe coming from 1st floor. [ 6 Answers ]

I'm finishing my basement in a newer house and want to add a wet bar. There is a 2" PVC drain pipe coming from the 1st floor that is for the washing machine drain. It has a clean out plug on it also. Can I just add a wye or Santee for the bar drain and do I need an Air Admittance Valve for venting....

Outgoing Drain Behind Vanity Cabinet Not Aligned with Sink Drain Tube in New Sinktop [ 1 Answers ]

I'm installing a new vanity cabinet and new marble vanity top, both slightly larger than the originals. The problem we've encountered is that the drainage pipe that will exit sink water from the sink to the house -- the PVC pipe in the house/wall -- is not aligned with the new location of the sink...

View more questions Search