Furnace control module

Chilly girl Posts: 1, Reputation: 1

New Member

Sep 23, 2012, 07:20 PM

Furnace control module

Can you tell how long a control module has been
Broken?

ma0641 Posts: 15,675, Reputation: 1012

Uber Member

Sep 23, 2012, 07:53 PM

No, they just break and have no time record.

Add your answer here.

Check out some similar questions!

Draft inducer or control module [ 0 Answers ]

I have a consolidated industries hot air heating system and I am having a problem with the draft inducer going on and off by itself even if I shut off the thermostat. I can hear the control module clicking on and off when the motor goes on and off and was wondering if it could be a bad control...

How to test furnace control module [ 4 Answers ]

How to you test the Honeywell S8610U3009 furnace module and circuit board with the meter ! Gas company claims the control module or circuit board could be at fault due late ignition !(5 minutes ) Module will cost $96.10 to replace and are not returnable!? Al

My furnace won't light and the lights on my control module won't come on [ 2 Answers ]

Ok a couple of question if you can help I have a comfortmaker furnace I believe 1999 it came on a couple of times after I bought a new transformer, board, capacitator, and ignition control module now it won't come back on What to Do! Also I wanted to know if you can tell me the difference between...

Ignition control module short where? [ 3 Answers ]

I have a 1991 Ford Ranger 4 wheel drive with the 2.3L 4 cylinder engine. It has new wires, coil packs, and crank shaft position sensor. There are no burnt wires, fuses, or fusible links. There are also no chafed, pinched, or loose wires or connections in the harness yet I keep burning the Ignition...