 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Tool for marking drill holes
As with the hose bracket and other tubular pipe
It is hard to mark the wall for an anchor. The pencil Is too thick to fit into the hole. I guess you could get A large thin punch or nail and mark it that way. Or is there a very thin pencil to mark the wall. |
||||
|
|
|
||||
|
The nail approach is easiest. You could also lay a sheet of paper over the tubing and do a rubbing over the holes, then transfere the papper to the wall.
|
||||
|
|
|
||||
|
Thank You
|
||||
|
|
| Question Tools | Search this Question |
Check out some similar questions!
Can you drill holes in ceiling joist which supports the upstairs master bedroom to rewire a kitchen without compromising the support of the upstairs?
I drill a hole through the board into the cement. I take the board off and put A plastic anchor in the cement. But when I try put it back the board , I cannot match the Hole in the cement. There are no border boundaries to go by. The board may not be Near any corner Is there a...
I'm running 1 1/2" pvc for a basement bathroom vanity and a wet bar. Do I need to get a Forstner bit or is just a regular hole saw best for drilling my 2x6 wall studs? Also, is 2" the correct size, or should I go to 2 1/8" or 2 1/4".
What is the best, most efficitent, cheapest way to drill a holes in shells. I have lots of shells that need to get small holes drilled in them, but it seems that shells are very hard and it takes an incredibly long time. I have used a hand drill with an ordinary drill bit and it worked OK but took...
Hi, I'm putting some beer taps on my fridge, and was wondering if it will be safe to put them on the side of the fridge. I've modified a fridge like this before by going through the door, but if there are no cooling pipes etc. in the side I'd rather go through there as it's stronger than the...
View more questions Search
|
