Ask Experts Questions for FREE Help !
Ask
    richard hoover's Avatar
    richard hoover Posts: 1, Reputation: 1
    New Member
     
    #1

    Sep 21, 2012, 08:11 AM
    Very hard to pull through my ryobi 2cycle weedeater.
    My ryobi weedeater pulls about 4 inches and stops then I must pull harder till it releases and pulls through another 4 inches until the entire length of starter cord is exhausted. I almost wear out my arm in doing so.sometimes I ask my neighbor to help me.why is this happening?all I did last year was drain my gas and put away inside.
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
     
    #2

    Sep 27, 2012, 09:25 AM
    Hi,
    Barring a split starter rotor, I would say you have liquid in the cylinder increasing the compression ratio. Remove plug and pull through to blow free.
    Peace,
    Clarke

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Ryobi weedeater spinner head [ 9 Answers ]

My Ryobi spinner head does not turn all the time. I replaced the shaft insert on it as the good one had a round on the upper part of it. Any ideas why my trimmer head doesn't turn? Is it in the trimmer head or perhaps in the top part? Thanks for any help.

Repacing pull cord on Ryobi weedeater [ 3 Answers ]

Need to replace pull chord

Ryobi Weedeater will not turn the head [ 1 Answers ]

The head will not turn on my Ryobi Weed Eater. What is the problem?

How to restring a ryobi weedeater [ 1 Answers ]

I need to know how to restring a ryobi weedeater

Ryobi dual string weedeater [ 1 Answers ]

I can't restring it... somebody showed me how a while ago but I don't remember


View more questions Search