Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
How to remove adhesive on a 50 year old metal sign
[ 0 Answers ]
I recevied a Mail Pouch metal sign from my father in-law recently and at each corner it was protected by cardborad which had some type of adhesive to keep it in place. I have use regular house hold products and a couple of Goof Off products. I want to be careful not to damage the paint. When Pulled...
How to clean acrylic adhesive off a marble floor
[ 0 Answers ]
How would I clean acrylic adhesive used to lay wall tile off my granite floor?
Can Nashua 324 Tape be use on the INSIDE of metal duct at furnace out take?
[ 9 Answers ]
I've used nashua 324A tape to seal up the custom metal duct I had to create to connect up my furnace to the existing heating duct. I used it on the inside and outside and was wondering if I'm at risk of a possible fire. The tape is rated to 325 degrees but I just wanted get some confirmation...
Clean-out cover needs teflon tape?
[ 1 Answers ]
Hi, Do I need to put teflon tape on the threads of a cleanout cover, or will screwing it in good and tight prevent any water from coming out? Thank you!
Metal tape on furnace flue?
[ 6 Answers ]
My furnace flue is a double walled pipe, 6-inch (I think) inside 8-inch (I know). It goes up through a chase in the middle of the house to the attic, where it basically comes out of wooden framework and continues on to the roof. The chase is open to the attic. I want to close off the top of the... View more questions Search
|