Ask Experts Questions for FREE Help !
Ask
    minx1970's Avatar
    minx1970 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Sep 9, 2012, 02:57 PM
    Wait to start light won't come on
    I have a 1997 Ford F250 superduty with a 7.3 engine. Afetr replacing the relay it still won't start. Any suggestions?
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #2

    Sep 9, 2012, 03:27 PM
    . Check for codes.

    . Check all under hood and under dash fuses with a test light or multimeter.

    . Clean the main PCM ground.

    . Check the ignition switch for wear, pitting, or melting.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Propane Furnace won't start no pilot light red light flashes 3 times [ 6 Answers ]

My propane furnace G6RC has no visible flame and the red light either stays on or flashes 3 times in a row and then the furnace shuts off and tries to restart

My start light on the dishwasher flashes try the reset but light contnue to flash [ 1 Answers ]

My 2001 Silverado won't start sometimes unless I wait 10 or 20 min intervals [ 1 Answers ]

My 2001 Silverado won't start sometimes, unless I sit and wait try again if not sit and wait. Sometimes it may take up to 30 min to get it started. I have tried a new fuel filter and a lot of fuel injector cleaner. I have taken it to a dealer and they say there is no chip in my key to go bad. ...

Car will not start no power, then dash light come on but will not start [ 1 Answers ]

When attempt to start there is no power , radio has lost power and code has to be inputted. Light in dash pane come on and there is clicking when attempting to start but will not start. Battery is good.

Wait propane heater pilot light assembly [ 1 Answers ]

I was recently given an older waite propane space heater and tried to light the pilot light. It wouldn't light so I took the line off from the control box to the pilot light assembly. The pilot light end of the line has a block in it that appears to be from factory, of course there can be no gas...

View more questions Search