 |
|
|
 |
New Member
|
|
Aug 30, 2012, 06:06 AM
|
|
My car has no spark wats my issue it's a 1997 chrysler cirrus
I'm having such an issue with my car it's a 1997 chrysler cirrus 2.5 it shut off on me comeing home from work about a month ago I've replaced a lot of stuff in it cause everything shut off but I still had power and it will crank just had no fuel and no spark I replaced fuel pump , fuell filter crank shaft cencor and my distibutor I have fuel now since I replaced my crank shaft cencor now what's my issue still no spark only thing left is my brains is what I've been told however if it turns over just isn't catching how would it be my brain??
Sincerelly lost and confused and $500 in the whole on this thing
|
|
 |
Uber Member
|
|
Aug 30, 2012, 06:35 AM
|
|
I would verify all fuses and test out of ignition switch.
|
|
 |
New Member
|
|
Aug 30, 2012, 06:44 AM
|
|
I've checked all fuses and it will tun\rn over just not catch would that still be a ignitions switch?
|
|
 |
Uber Member
|
|
Aug 30, 2012, 06:55 AM
|
|
Yes, the ignition switch not only cranks engine, but provides power to Ignition circuits. I would get the Service Manual. It will save you or anyone who works on it, Time and Money. The Schematic will tell where power should be.
|
|
 |
Uber Member
|
|
Aug 30, 2012, 07:02 AM
|
|
Check for codes. Does the Check Engine Light come on and go off when the ignition switch is turned to ON?
|
|
 |
New Member
|
|
Aug 30, 2012, 07:03 AM
|
|
I didn't get the service manual with it but I will try that it can't hurt... thanks
|
|
 |
New Member
|
|
Aug 30, 2012, 07:04 AM
|
|
I've pluged in a computer it won't pull any codes it says n/a for every thing
|
|
 |
Uber Member
|
|
Aug 30, 2012, 07:12 AM
|
|
Clean the main ground to the ECM. If the ECM still acts funky, try testing for 5 reference volts at a key sensor. If none, or low, consider substituting a different ECM.
|
|
 |
New Member
|
|
Aug 30, 2012, 07:13 AM
|
|
 Originally Posted by TxGreaseMonkey
Check for codes. Does the Check Engine Light come on and go off when the ignition switch is turned to ON?
Yes the check engine light comes on when key is turned on it was ojn when it broke down also
|
|
 |
New Member
|
|
Aug 30, 2012, 07:15 AM
|
|
OK dumb founmded what's the ecm? Like my brain??
|
|
 |
Uber Member
|
|
Aug 30, 2012, 07:15 AM
|
|
If the CEL stays on, when the ignition switch is turned to ON, attach a code reader to the Data Link Connector and tell us what codes were thrown.
|
|
 |
Uber Member
|
|
Aug 30, 2012, 05:12 PM
|
|
Electronic Control Module, a Brain.
|
|
Question Tools |
Search this Question |
|
|
Add your answer here.
Check out some similar questions!
Chrysler lhs 1997 dies out while driving
[ 1 Answers ]
My car starts up and I drive it a few miles then it dies out. When I tried to start it up again it would make a sound. I would wait a couple of minutes then it would start again. I
Would drive it a little more then it would die again with the steering wheel hard to turn.
View more questions
Search
|