Control box keeps getting hit by lightining

ccustodio Posts: 1, Reputation: 1

New Member

Aug 15, 2012, 04:15 PM

Control box keeps getting hit by lightining

Control box for an electrical motor keeps getting hit by lightining, what can be done to prevent this

Stratmando Posts: 11,188, Reputation: 508

Uber Member

Aug 15, 2012, 05:04 PM

Control Box for what, Antenna System, underground pump?

Add your answer here.

Check out some similar questions!

My 27 yrs. Old daughter hit me, swears at me and tries to control my life [ 6 Answers ]

I am a retired 62 yr. old single mother. My 27 yr. old daughter constantly yells at me, swears at me and for the first time has hit me twice in an angry rage. While a few female friends and I were on a recent vacation she took it upon herself to change the locks on the house so that a man that I...

Hit and run but son was ticketed for failure to control--Ohio [ 4 Answers ]

My son was run off a dirt/gravel road by a young man who threatened him 2 times earlier that week. There is a mark on my sons bumper (drivers side rear) where the other driver bumped him with the tow ring on the front of his truck. The hit and run driver sold his vehicle just a couple days after...

Lightining protection cable [ 1 Answers ]

Do I need insulated or non insulated cable for lightining protection on PEB steel building??

Have to hit reset button on bottom of control box to get well pump to run [ 1 Answers ]

To get the pump to start I have to hit the rest button on the bottom of control box, the pump will then run as normal fully charging the tank until pressure vale kicks it off, it will run water for quite some time before pressure gets low enough to kick the switch back on but I have to reset the...