 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I have an attic that was done thusly: from the outside in, shingles, plywood , an airspace, pink batt insulation, 2" blueboard on the interior surface, 6 mil. Plastic on top of that, tongue and groove pine as an interior finish. I'm thinking I have to remove the 6mil. Plastic as the blue being...
Brand new home (2700 square foot raised bungalo), been here about one year. Lots of condensation behind vapour barrier in basement. Humidifier turned off, have "two" dehumidifiers going, (for months), cut slits in vapour barrier (will repair when dry), cannot seem to reduce condensation. 1: What...
Hey guys, I am at a crossroads. Here is my set up. Retangular prefab (Maax) shower base. Enclosed by three sides. One side is and exterior wall that is insulated and vapour barriered. The other two walls are interior. One wall being within the bathroom (wetwall) and the other sharing the wall...
I have a log home. The roof looks to be - 2X14 planks laid onto logs covered with tar paper, then another layer of planks and tar paper, then looks like 3/4 inch plywood more tar paper, and finally tin this all appears to be tied in with upright 2X12s about 12 inches high with insulation placed...
I am renovating a kitchen and have taken down some of the interior walls and plan on taking the drywall off the ceiling above which is attic space. There is avapour barrier but it is not 6mil which is proper vapour barrier. Can I apply another layer of 6mil plastic vapour barrier directly against...
View more questions Search
|
