Ask Experts Questions for FREE Help !
Ask
    sport54's Avatar
    sport54 Posts: 1, Reputation: 1
    New Member
     
    #1

    Aug 3, 2012, 06:29 AM
    Trane md# 2ttr3048a1000aa
    The capacitor failed on my unit, it's been replaced but the compressor will not start up, could it be that the hard start relay is also bad or what else might I look for?
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
     
    #2

    Aug 3, 2012, 08:29 AM
    trane md# 2ttr3048a1000aa
    sport54 sport54 is offline (1 Posts) Asked Today, 09:29 AM — 55 Views Edit Report
    the capacitor failed on my unit, it's been replaced but the compressor will not start up, could it be that the hard start relay is also bad or what else might i look for?


    First you might try checking the circuit breakers and the fuses in the outside disconnect if so equipped.

    Next look where the wires go to the compressor under the cover that is on the compressor. They have been known to burn off and need to be repaired.

    So far those two ideas have been free except for your labor.

    Now on the hard start part issue. If your unit has a factory start kit it could be bad BUT usually if it is bad the compressor will try to start and fail so you should hear a noise at least from the compressor. If you do not hear any noise from the compressor at all I feel it would not be the hard start setup.

    There are other possibility's that are in the low voltage arena. Is the contactor/starter pulling in? Is the 24 volt signal getting to the outdoor unit to activate the contactor/starter?

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

What trane programmable thermostat can I use with my XL13I trane heat pump [ 1 Answers ]

Can I use the 800 series thermostat with my XL13i trane heat pump?

How to wire a trane 900 series thermostat to a trane XL13i heat pump [ 1 Answers ]

How to wire a trane 900 series thermostat to a five wire XL13i heat pump system.

Trane heat pump trane o/b valve setting [ 2 Answers ]

I have a trane xl1200 (I think) heat pump and don't know if I need to set the thermostat setting on the OB Valve to.. 1) O/B terminal controls valve in cooling or 2) O/B terminal controls valve in heating. Thank you for your help, Kevin Baker

Trane XL20i heat pump requires Trane 900 series thermostat? [ 2 Answers ]

Hi, I was wondering if the Trane XL20i heat pump requires the use of Trane's 900 series thermostat or if a Honeywell VisionPro IAQ thermostat can be used.

Quote on 2 1/2 ton Trane XR13 and var spd Trane Blower [ 2 Answers ]

I was just quoted on a 2nd floor A/C replacement, condenser and var speed blower, 2 1/2 ton Trane XR13 with upgrade options. Live in CT Are these prices sane ? Includes removal of old unit, upgrade of refrig line, added insulation on old ductwork - work to be done in walkup attic Quote...


View more questions Search