 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Troy bilt rider
Hello
I have a rider with steering column bearing worn out and don't know how to replace . Will drop the deck to get to bottom of column nut , but does the whole column come out from the bottom or top .I have taken the sreer. Wheel off to see if that would help? Mod # 13AJ 609G766 Ser. 1D215H200379 And do I get the parts from loels or sumplace else.. Thanks randy |
||||
|
||||
|
Hi,
I gather it is the bottom one and held in place by the steering column and fasterners. There should be a 1/4" bolt in it, up from the bottom. Remove it , washer and spacer and the steering column should slide upwards for access. Peace, Clarke |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I need to replace the drive belt on my Troy Bilt riding mower. The model # is 14AT809H766. The belt # is 954-0468. Thank you.
Hi , I'm a novice at this, so I've done all I can think of. I thought it was the battery, so I recharged it. Still no start. I made sure everything was in the right setting. No luck. I just went out and bought a brand new battery... nothing. I figure I must have the thing hooked up wrong, but...
I have a 2004 troy bilt 42" bronco rider with a 18.5 b & s engine. The brake switch is broken and I would like to know the best way to get to it to replace it. Thank you for your time.
Purchased a new troy bilt 4 cycle tiller, less than 10 hours ran great. Now will only run in chock, will allow to go half way to half chock,idles up, but can't get enough power to till. Any help will be greatly appreciated. Wes
My pto will not engage how do I check if relay or switch is bad? I checked at the plug for the clutch and I am not getting power. Troy-Bilt lawn tractor.
View more questions Search
|
