 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Ask Electrical Questions
Dear sir, I have got a new house, the electrical company put in three meters,
So I have three breaker panels, they did not put in main disconnect switches, When I asked to have them installed, they told that I would have to have three Separate ones, the cost was prohibative. My question is, is it possible to have One box to put all three switches in it. Any advice you can give me will be Greatly appreciated. Sincerely B. Robinson. |
||||
Check out some similar questions!
Hi, I have a power drop to a power shed on a rural piece of land, 200 amps, and want to split from there taking one power cable to a cabin and another to a shop. It is 90 feet to the cabin and 230 feet to the shop. I am either going to do 100 amps to each, or 60 amps to the cabin and the rest...
Can I replace a mail breaker in a Blakeman Brothers main panel with a quad breaker of a modern manufacturer? And what type breaker will work?
Switch position reverse. I have 120v coming from the breaker to the switch box. The box has the in and out white wire tied together and the in and out ground wire tied together. The black wire in and out goes through a single switch. It works fine, but switch positions are reversed On is off...
I have recently replaced a lightpost in my yard which had an outlet in the center of the post. The outlet only worked if the light was on. The light was controlled by a hard wired timer which had a black, white, red and green wire. I assume the red and black juiced the outlet and the light. The...
Installing dimmer switch there is hole in wall but no box, their was a switch their attached to dry wall This is a modular home. Should I add a cut in box then put switch ? And there is three wires no 2 just tie all whites together and all blacks and grounds right?
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
