Ask Experts Questions for FREE Help !
Ask
    lgunderson's Avatar
    lgunderson Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jul 4, 2012, 08:21 AM
    Trouble Shooting Briggs & Stratton Model 286h77 0165E1
    When at a slow idel it runs OK at higher speeds it backfires and quits running. Also under a load it will not stay running it backfires and soumnds like it is going to explode
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
    		  
    #2

    Jul 15, 2012, 11:53 AM
    Hi,
    Diverse things can cause this. One would be a partially sheared flywheel key. Another would be a partially blown head gasket. Still different would be something wrong with the valve train. And finally a failing armature that is having the builtin advance system failing. Inspection is in order and always start with the least expensive. The head gasket can be inspected with a flashlight shone between the fins to where the cylinder meets the head. The valve cover can be removed and the clearance checked, rocker arm pivot bolts inspected for loosening and pushrods for bending. All this with only time involved. They proceed to the key, and the armature would be last since it involves the most expense. All the while in the inspection, the wires for the ignition ground should also be inspected for bare spots.
    Peace,
    Clarke
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Briggs Stratton 16.5 h.p. Trouble shooting? [ 8 Answers ]

I have a briggs stratton 16.5 model 313707 when I try to start this, it won't spin the flywheel. But if I take out the spark plug it will spin just fine. What is this problem.

Briggs & Stratton 5 HP model 130292 [ 8 Answers ]

I have a rototiller with a Briggs & Stratton 5 HP motor, model 130292. The motor makes a high pitch squeal while running and the starter rope comes out a few inches. I see by a previous post that it might be the clutch assembly. How can I verify before I order the part?

Trouble shooting briggs & stratton 19.5 hp engine? [ 0 Answers ]

Have a craftsman 19.5 H I/C Platinum engine. Sat outside for 3 years. Tried to bench start it with a new 12volt battery (engine is not in the tractor). Engine turns over one slow revolution at a time. Cleaned all: contacts, carb, plugs, air filter, fuel filter. Won't start. What can the...

Briggs & Stratton 3.5hp Model 98902 [ 2 Answers ]

I have a Bolens Edger with a 3.5 Vertical Shaft Briggs which I purchased used with this problem: After priming the carb, the motor will start (it may take a couple of tries to keep it running) Once it keeps going, the engine seems to oscillate (revs up and dies down, revs up and dies down...

View more questions Search