Ask Experts Questions for FREE Help !
Ask
    dnssr's Avatar
    dnssr Posts: 1, Reputation: 1
    New Member
     
    #1

    Mar 1, 2007, 04:46 PM
    How to find the right size fuse
    I have 240v circuit and a solenoid that I want to know what size fuse should I use.
    caibuadday's Avatar
    caibuadday Posts: 460, Reputation: 10
    Full Member
     
    #2

    Mar 1, 2007, 08:05 PM
    Quote Originally Posted by dnssr
    I have 240v circuit and a solenoid that I want to know what size fuse should I use.
    What size of wire is between the solenoid and the fuse? the FUSE's AMP should be smaller than the wire, and at least equal or greater than the solenoid.. there should be a rating, nameplate, on the solenoid

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Blown Fuse [ 1 Answers ]

A brief background before the problem occurred. This morning I was caught in a traffic jam, wherein I had to idle the car for about 15 minutes. Thereafter the driving was normal until I stopped at a traffic signal for over 145 seconds. This time I had switched off the engine. I was unable to...

Sizing a fuse [ 6 Answers ]

I have a 30 watt heater 240 Vac What size fuse should I use? Is there a formula?

Looking for a Fuse [ 1 Answers ]

Can't find this fuse anywhere. I've checked ACE Hardware, Radio Shack and several sites on the web. BUSS AGA 3A 125V This fuse is the standard 1/4'' dia and 9/16" long. Any help will be appreciated.

Thermal Fuse [ 3 Answers ]

I have a whirlpool le2500xtw1 dryer, I bought used.it worked fine for about a month, then one day it would run but not heat. First thing I did was get a new element. But the problem was the thermal fuse was blown. The replacement package had a new thermostat as well as the fuse. After a few days of...

How to determine which fuse size I need? [ 2 Answers ]

I've just installed power door locks in my Honda Civic, and I've placed a fuse holder along the wire that goes from + terminal to the door lock relay. First of all, should it be on the + side of the battery or the - side? More important question is, how do I determine the fuse size that I...


View more questions Search