 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
goodman variable speed motor B13400704ABS
hello
I have a variable speed motor that's going on and off, I can tap the motor and it will start again, but may stop again, and try to start again, doing a little start/stop pulse, I've hit it again and it's been going for several hours now, looks to me that the motor is going bad, just over 5 yrs old, but thought it should last longer than that, can someone tell me if it is the motor, or could it be the 'end bell' with the board? If it is the end bell, should I replace the whole motor? Thanks for your help Brian |
||||
Check out some similar questions!
the variable speed motor on my AC unit went out and it is very expensive to replace. I was told I could convert to a fan with a relay, which is much cheapers. What are the pros and cons of doing this and is it recommended?
If so, can I buy the relay separately or is it part of the control board?
A controlling variable is a motor speed that varies from 800 to 1750 rpm.If the speed is controlled by a 25- to 50- v dc signal, calculate (a) the speed produced by an input of 38v, and (b) the speed calculated as a percent of span.
My goodman 95% furnace has themals on the blower fan they get hot and trip out.It has done this four times in the last year.I reset them and it works for a while four weeks may be and does it again. I replace the control board. Same problem now I want to replace the blower DC variable speed...
The fan hasitates to star It tries to move and the after a minute it will run. I try to set the dip swithches for no delay after running but no imprument, The problem with this is that the coil inside gets frozen since no air is circulating, I caom with a temporary solution a delay circuit on...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
