Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Explain which wire is ground wire when you have 2 black wires and 1 white wire
[ 5 Answers ]
Explain which wire is ground when you have 2 black wires and 1 white wire
Is hot wire is not a neutral wire or vice versa in single phase two wire AC source?
[ 1 Answers ]
I am a little bit confused why in AC single phase 2 wire source is merely classified the 1 wire as hot and other wire as neutral. The hot wire travels the current from the source to the load and going back the current to the source through the neutral wire. I know that in AC circuit, the signal or...
Black wire red wire and white wire spliced to 10/3 on a 220 circuit
[ 25 Answers ]
I have installed a disconnect between my dryer receptable and a tanning bed. I want to splice the 10/3 box wire to the existing 220 wiring at the dryer. Dryer= red, black, white and bare ground wires 10/3 wire= black, white, and bare ground How do I splice these to allow the disconnect box to...
How to wire my new Briggs & Stratton engine
[ 4 Answers ]
I bought a Briggs & Stratton Vertical OHV Engine with Electric Start 17.5 HP, 1in. X 3 5/32in. Shaft, Model# 31C707-0005-G1 to replace the engine on my Swisher trail mower. The old engine was a pull start so obviously this new engine has more wires. I bought a 5 tab switch and I did get most of... View more questions Search
|