Not your question?
  Ask your question
  View similar questions
   
  
 Add your answer here.Check out some similar questions!
How to change the pto oil seal on a 18.5 hp briggs and stratton engine
 [ 1 Answers ]
 How to change a pto oil seal on a 18.5 hp briggs & stratton 
Engine oil mixed with coolant after oil seal ring failure what next?
 [ 0 Answers ]
 OK MY 97 jetta was spewing oil from above the filter cranked the car and the oil light came on. Checked the oil level and discovered antifreeze mixed in the oil. Is it a blown head or possible that d/t oil cooler o-ring failure that it leaked into the engine? Should I flush out oil and change... 
Synthetic Blend oil and new main/cam seal conflict?
 [ 2 Answers ]
 I just had the rear main oil seal replaced (3rd time) as well as the front cam seal(2nd time). On my 1996 Mercury Villager 3.0 V6 128K I had all kinds of problems with this shop and was glad just to get it home and when I did I had my low oil pressure light on which I never had before, big... 
Change differential oil seal
 [ 1 Answers ]
 How do I remove and replace the transaxle oil seal on my 1999 sears 22hp tractor 
Removing Oil Seal
 [ 9 Answers ]
 
I have a Murray 18.5HP mower which is leaking oil badly onto the stack pulley. I am "assuming" this is due to a bad oil seal on the PTO side. I have bought the new seal and I am ready to put it on and I am wondering what is the best way to go about it. I have taken the deck off already. Is the... View more questions Search 
  |