Not your question?
  Ask your question
  View similar questions
   
  
 Add your answer here.Check out some similar questions!
How do I reassemble tub a push n lock tub drain?
 [ 10 Answers ]
 I took a push n lock type tub drain apart to replace the washer. There are 2 springs, several plastic parts, one large screw and the top. How do these parts fit back together? 
Drain in tub does not line up with pipe underneath tub.
 [ 1 Answers ]
 I have a whirpool tub that was draining slowly, so I took out the stopper and when I looked down the drain it was off center, by half. Should it be like that due to the type of tub/venting or whatever? Or is it installed wrong? How do I fix this? 
Run water in tub drains. Fill tub does not drain
 [ 3 Answers ]
 Run water in tub drains. Fill tub does not drain use snake but its still the same 
Tub drain in concert is too low for new spa tub
 [ 1 Answers ]
 Greetings everyone, I am installing a whirlpool tub and it appears that the drain is about 1/2 inch too low. The drain is set in concrete. Is there any type of extension that can be put on the drain? Any suggestions? Thanks, Ed 
Slow Tub Drain; Draining Sink Overflows Tub
 [ 8 Answers ]
 
Hello! I'm looking for advice about some bathroom plumbing issues. We live on the ground floor of a condo building that has a cement slab. The tub in our bathroom has an extremely slow drain (ankles submerged during a shower). We've tried to snake the tub drain both through the drain and by... View more questions Search 
  |