Ask Experts Questions for FREE Help !
Ask
    cmanto's Avatar
    cmanto Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Jun 21, 2012, 11:12 AM
    Maytag neptune dryer mdg4000bww does not fire up
    Gas dryer does not fire up
    drtom4444's Avatar
    drtom4444 Posts: 3,282, Reputation: 145
    Ultra Member
    		  
    #2

    Jun 22, 2012, 02:02 PM
    Here is a manual: https://dl.dropbox.com/u/8010163/May...e%20Manual.pdf
    You can test the different components of the gas system and find the problem. Most problems are from dirt build-up and a burned out safety. When it gets very dirty the main safety blows, but often the hi-limit is bad, too. The contacts weld shut on the hi-limit and then the safety blows. Tear it down, clean it, and find the blown safety and it will run fine. You must be very thorough and take out the ducts and wash them out or it will fail again.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

My maytag neptune mdg4000bww stopped heating [ 1 Answers ]

I opened the front of the dryer,cleaned it out and let it run,and saw no ignition to heat the dryer... I also found pieces of a flint stick in pieces on the bottom of the machine... now what?

Where is the Igniter on a Maytag Model MDG4000BWW gas dryer? [ 1 Answers ]

Which panel do I remove to access the Igniter on a Maytag Model MDG4000BWW gas dryer?

How to change door switch AP4319999 on maytag neptune dryer. Dryer won't start [ 2 Answers ]

Neptune Dryer Stopped Heating M/N MDG4000BWW [ 4 Answers ]

Hi, Please Help! My girlfriends dryer stopped heating suddenly. It's a Maytag Neptune Model MDG4000BWW. There is no heat whatsoever. I am hoping there is something inherent with this model that I can start with. Any suggestions will be greatly appreciated. Thanks.

Maytag neptune mdg4000bww dryer [ 1 Answers ]

Ok I've got a Maytag Dryer, that will not heat up, I've pulled the cover off, and check to see if the igniter is firing up properly, sure does, I thought it might be the gas valve solenoid, but if that were the case, no gas would go through, however I open the door (I put it back on with the cover...

View more questions Search