Ask Experts Questions for FREE Help !
Ask
    acuravila's Avatar
    acuravila Posts: 1, Reputation: 1
    New Member
     
    #1

    Jun 18, 2012, 12:27 AM
    9Havcura integra Ignition coil replaced but cut the wires to relase it..
    I have a 95 acura integra replaced igntion coil but cut the positive and negative wires to remove the old one.. and reconnected together with add on wire. Also bought new spark wires but no sparks.. need help starting
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
     
    #2

    Jun 18, 2012, 06:21 AM
    Also, replace the Ignition Control Module (ICM) inside the distributor. Apply silicone heat transfer grease to the back of the new ICM.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Sears lawn mower, 5.5 hp no spark, replaced the spark plug and ignition coil . Stuck [ 1 Answers ]

Model 917373982 sears mower 5.5 hp, no spark replaced the spark plug and ignition coil. I'm stuck

My blower on inside unit will not cut off I cut and crimped wires back together [ 1 Answers ]

Where do I put the blue and red wire to the blower on the inside unit

98 Civic lights pulsing after replacing ignition coil and plugs/ wires [ 3 Answers ]

1998 Honda Civic EX coupe, 222K miles, original owner, timing belts/ water pumps changed every 100K Car just stopped while driving Sunday, we did some research and decided to replace the ignition coil... my brother is mechanically inclined but not familiar with Hondas. So he replaced it, and...

Ignition Coil [ 2 Answers ]

Im the owner of a 2000 Chev Impala. The problem is while driving along my car began jerking and stalling, then it stopped running. Ive tried replacing the ignition control module and the coils with no luck. Any ideas? For some reason, the distributor isn't firing.

Replaced coil in new a/c [ 4 Answers ]

Hi - I had a brand new furnace & a/c installed in Oct 2006. When I went to use the a/c in early May, there wasn't any cold air. The HVAC company came out a few times and finally decided to replace the coil on top of the furnace. They said it had a leak and that is where the refrigerent was...


View more questions Search