Ask Experts Questions for FREE Help !
Ask
    niloc540's Avatar
    niloc540 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jun 9, 2012, 09:12 AM
    Sabre Lawn Tractor 2046HS
    I have just changed the mower belt and it is correctly routed. When the PTO is engaged the belt is tight and the mower blades will turn fine. But when the PTO is disengaged the belt is too slack and I'm afraid it will jump the pulley and damage the belt. The belt can be taken off the pulley with no effort. Is there any way to snug the belt tighter to the pulley.
    Thanks.
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
    		  
    #2

    Jul 8, 2012, 05:08 PM
    Hi,
    Please note that the left hand cover on the deck is also a belt guide. Close examination will reveal that it has two metal rods embedded in it at fron and rear.
    Peace,
    Clarke
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Sabre Lawn Tractor Maintenance [ 1 Answers ]

Mt Scott/Sabre 2046 will start and run fine as long as the clutch/brake pedle is depressed. The engine dies when the cluch/brake peddle is released. What could be the cause? Thanks.

Sabre 1546 lawn Tractor battery [ 1 Answers ]

I have a sabre 1546 lawn tractor and the battery dies after I turn off the mower. It does hold the charge while it's running. The solenoid, battery and starter are all new. Any suggestions

Sabre 2046 lawn tractor-solenoid [ 1 Answers ]

Where would the solenoid be located on a sabre lawn tractor. Any help would be appreciated; Thanks

20Hp sabre lawn tractor [ 1 Answers ]

How do you remove the 46" mowing deck on a sabre lawn tractor.

Sabre 1338 lawn tractor [ 4 Answers ]

My belt fell off and I can't find a diagram to put it back on. PLEASE help me my lawn is 2 feet high I need to mow

View more questions Search