 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Heating and air conditioning troubleshooting
I ran into a problem when in cooling mode the heat and the air conditioning is coming on I've done all the normal steps to trouble shooting the circuit and can't figure out what the problem is I even went as far as rewiring the circuit board according to the diagram and even changed the tstat and circuit board please help what am I missing
|
||||
Check out some similar questions!
Outside unit is on and fan spinning, but no cold air coming from registers. What might the problem be?
My York Diamond 80 furnace is blowing cold air. There is an indicator blinking twice. Is there a way to reset?
Wear safety goggles and gloves when working with refrigerant. Very important: Only add refrigerant to the low side port. 1. Fuse Testing. Test all under hood and under dash fuses with a test light or multi-meter. 2. Relay Testing. Verify that the compressor clutch relay and the...
I have a Carrier Weathermaker HE gas furnace. The motor was making a high speed rubbing sound at times, it would stop or start the noise when I pressed gently on the housing one way or the other. The repairman also discovered that the black plastic fan wheel also had a crack running from the...
My ruud Heating & Air Conditioning system is not blowing hot air, everything is working fine but not blowing hot air when I put it to heat
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
