Ask Experts Questions for FREE Help !
Ask
    Pcart's Avatar
    Pcart Posts: 2, Reputation: 1
    New Member
     
    #1

    May 31, 2012, 11:24 PM
    Why is the pump pressure high on my above ground pool?
    What is the recommended pressure reading on a above ground pool with Hayward sand filter system? Is 20 too high?
    Pcart's Avatar
    Pcart Posts: 2, Reputation: 1
    New Member
     
    #2

    May 31, 2012, 11:29 PM
    Recommended pressure for above ground pools
    I have an above ground pool and I have changed the sand in the filter (Hayward) and backwashed, rinsed and my pressure starts at 15 then gradually rises to 20 is this too high I have had to turn it off for fear it is after running for just several hours. What is the recommended pressure or the right pressure if everything is
    Working properly?
    for teri's Avatar
    for teri Posts: 1, Reputation: 1
    New Member
     
    #3

    Jun 19, 2012, 04:25 PM
    My poolpump pressure starts at 10 (clean) with good cirulation then within 10 minutes rises to 25-30 and the cirulation almost stops. This happens when I bump the filter and also when I back wash. So unless I do this every 10 minutes the water stops cirulating. It is also cloudy, won't clear up, all chemicals are at correct level.
    What is going on?

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

High pressure on pool pump [ 4 Answers ]

I have an above ground pool. When the filter is on the pressure usually stays around 30. Now it is registering as high as the gauge will go. I lost my manuals in Katrina. Can anyone help? Sorry.. the pressure usually stays at 15 now it is as high as it will register!

Water pump pressure builds too high and trips the pressure valve [ 1 Answers ]

First I had to replace the breaker for the water pump because the breaker must have went bad because I had no power to the pump. Fixed that and everything worked fine. I had to shutoff the water supply to repair a leak in a pipe. After I repaired the pipe I turned the water back on and got no water...

For a 19,000 gal above ground pool, what type of pump is best [ 1 Answers ]

I have an 18' above ground pool and the pump that came with it just didn't circulate the watervery well. It started OK . Then it started moving the water slower and slower,until it would be on,but didin't move the water at all. It stopped working completely as if the motor had burned up, within a...

Ground lug on outside of pool pump [ 3 Answers ]

If your pool pump housing is grounded via the green ground wire which goes back to the main braker box then why is there a ground lug on the outside of the pool pump?


View more questions Search