 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
Check out some similar questions!
Is it possible to wire a 120 volt fan limit switch to a 24 volt gas valve? If so how would you need to wire it?
I had an old fluorescent light with an outlet above my medicine cabinet. I replaced it but I had to put a rework box for the outlet. I got the light wired and working and have a question about wiring the outlet with I ran with 14/2 to the box where the light is mounted. I tested the wires...
I want to install 3 1200 watt heat lamps on my outdoor patio. I am planning on installing a new circuit, since I have an open slot on my service panel (200 amp). I was going to run a 30 amp circuit with 10-2 NM wire. However, I'm not exactly sure how to place the outlets and if they should be 20...
I'm installing a 240 volt electric baseboard heating system that has a total watts of 5,000. A 2500 and a 1500 watt unit will each have their own wall thermostat. Then there will be two 500 watt units each with their own unit mounted thermostat. I plan on using a 30 amp breaker and 10-2 wire. ...
Ok, I"ll try to explain this with the best of my ability. I have recently been trying to replace some of the light fixtures in my house. I have only lived in my house 3 months so I am not sure what I have yet. I only know it is 67 years old. What I noticed is there isn't black and white wires but...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
