 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
Check out some similar questions!
I have a 10 yr old unit that has a suction pressure of 110 abd a head pressure of 200 Its 90 degrees outside .Its a cap tube evap coil the house is not cooling at all suction line not cold at all It's a scroll compressor could it have bad valves?
Hello & thank you for your time. I have a 96 Toyota 4Runner. According to live data stream, the #2 cylinder is misfiring & 2 (155lbs), 4 (160lbs) & 6 (165lbs) were low when compression tested. 1, 3 & 5 tested fine. The vehicle runs rougher than it used to, especially at an idle. There are no...
I have a repeatedly-troublesome shower (see my prev threads) that I continue to fight with. Now my problem is that the shower line is stuck with low flow. It is NOT the shower head. It is clean and unobstructed. It flows fine if I put it in another bathroom. The system is a Delta, but the...
I had good water pressure but it has become less and less,so I removed the valves in the cold and hot handles figuring there was debris to be flushed out. When I turned water on with valves out the stream hit the back of the tub (about 5 feet). I flushed them out for a few minutes (rusty water,...
After replacing the rubber washers in the brass gerber valves (handles) and reassembling the handles, the water flow to the shower head was greatly reduced. The local lumber store didn't have all the washers and suggested I push plumbing string around the stem to stop the water from leak from the...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
