Ask Experts Questions for FREE Help !
Ask
    missykay04's Avatar
    missykay04 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Feb 25, 2007, 03:29 PM
    Whirlpool washer over flow
    What causes my cold water to not shut off after the washer has already filled?
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #2

    Feb 25, 2007, 04:35 PM
    There is a float connected to a shut off valve for your water inlet. The float can stick or not float but the solenoid in the valve can be bad. Check around the outside of the tub, the float is usually in a semi-clear plastic tube.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Whirlpool Washer [ 1 Answers ]

Help! The bottom part of my washer agitates but the top part will not spin. What can I do?

Whirlpool washer [ 1 Answers ]

Washer makes banging noise when going into spin cycle, then blows the circuit

Washer back flow [ 1 Answers ]

Our washer is overflowing from the drain pipe into the basement, what could this be? The toilets, shower or sinks do don't back up. Only the washer after 3-4 loads?

Whirlpool washer [ 8 Answers ]

I just purchased a motor coupling for my washer but do not know how to install it can someone please tell me how to. Thank you.:

Washer hose flow valve [ 3 Answers ]

I just bought new washing machine connectors at a national home improvement store. They are billed as flood preventative because they have a diaphram valve at the connector which shuts down water flow when flow exceeds 2.5 gpm. However, I can only turn on the water valves less than a quarter of a...

View more questions Search