Ask Experts Questions for FREE Help !
Ask
    noelect's Avatar
    noelect Posts: 1, Reputation: 1
    New Member
    		  
    #1

    May 7, 2012, 05:22 AM
    How to correct a switch loop
    I added a plug to my garage (both lights and plugs are on the same breaker and the lights are three-way). Once connect everything worked except - I can't turn off the lights using the switch. What have I done wrong?!
    hkstroud's Avatar
    hkstroud Posts: 11,929, Reputation: 899
    Home Improvement & Construction Expert
    		  
    #2

    May 7, 2012, 05:34 AM
    Well, you have to tell us exactly what you did when you added the receptacle.
    Missouri Bound's Avatar
    Missouri Bound Posts: 1,532, Reputation: 94
    Ultra Member
    		  
    #3

    May 8, 2012, 11:47 AM
    Where did you tie the receptacle in... at one of the switch locations? Do either of the switches work? Can you provide more details please?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Why won't my wall switch shut off my new light? All my connections are correct. [ 3 Answers ]

I have the white wire connected to one wire from my light. I have the red and black wires connected to the other wire from my light

What is the correct way to install a relay switch to furnace [ 0 Answers ]

I have the info that is on my furnace and it is a honeywell pdf/packedlit/69-06po-pdf My boyfriennd says it says 40165.67549-306 I don't know if any of that info will help but there it is I can not find any diagrams on how to hook up the new relay switch so please if anyone knows how to please...

Ceiling light and switch loop w/BX: insulation and colors [ 2 Answers ]

It's been a while since I've done this and reading here tells me the codes have changed a bit, so I ask: I plan to replace the light circuit in a basement. The original wire is 75-year-old BX and there are some 50-year-old changes that never met code. Also, we need more fixtures; temporary...

4 lights switch loop wiring [ 5 Answers ]

I am wiring a room with 4 recessed cans. I have made sure that the circuit would not be overloaded and need help wiring it this way: Power >>> can 1 >>>can 2 >>>dimmer switch >>>can 3 >>>can 4. If this way of wiring is a potential hazard or code violation (US), please let me know. Thanks!

Consistent Switch Loop Wiring [ 7 Answers ]

TK - Strat- KISS-Labman - et al.. This question only applies to overhead sourced switched loops. 14/2 to 14/2 - I have been taught that for a two wire switch loop, the Black from the Source goes to the Black to the Switch. White from the switch is recoded with tape and connected as the...

View more questions Search