Ask Experts Questions for FREE Help !
Ask
    TRUCKERBABE's Avatar
    TRUCKERBABE Posts: 1, Reputation: 1
    New Member
     
    #1

    Apr 22, 2012, 06:53 AM
    Mower runs but will not engage the blade, how do I fix?
    The mower will run but the blad will not engage, it will turn occasionally but rarely and I do not know what is wrong with it.
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
     
    #2

    Apr 22, 2012, 10:30 AM
    Hi,
    Unfortunately, I do not know what you own, so I cannot begin to give much of an answer.
    Peace,
    Clarke

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Lawn mower blade won't engage [ 2 Answers ]

I tried to mow my grass the other day, and when I pulled up the knob on my Troybuilt riding mower, to engage the PTO, it acted like it was going to engage, and then didn't. The whole attempt lasted only a seconds. I tried again, several times, and it did the same thing. I checked to see that the...

Weedeater Riding Mower, Blade won't engage [ 2 Answers ]

We have a Weedeater riding lawnmower model 733-848 or HD12538j. The blade will not engage and I found a spring that fell out. I can't tell by the manual where it goes.

Craftsman rear engine mower,runs fine,mower deck will not engage or cut the grass? [ 2 Answers ]

Rear engine craftsman mower runs fine,but the mower deck does not engage when you lower the lever?it appears the belt is on the pulleys,help...

How to engage mower blade [ 1 Answers ]

I have a used Murray riding mower that does not have a manual. I need to know what adjustment or repair is needed to "engage" the mower blades. Nothing happens when I push the handel forward. I adjusted a screw type device (just above the deck) that increased the torque one time before that...

Cable snapped on blade engage Craftsman Mower [ 1 Answers ]

The cable that is attached to the engaging knob has rusted and snapped so now I can't engage the blade. What do I do? Easy repair or headache?


View more questions Search