Ask Experts Questions for FREE Help !
Ask
    tmaust's Avatar
    tmaust Posts: 1, Reputation: 1
    New Member
     
    #1

    Feb 22, 2007, 10:54 AM
    Gas furnace fan jingling
    My gas furnace (14 years old) buzzes on start up and the fan jingles on shut down. What could be the reason for this?
    NorthernHeat's Avatar
    NorthernHeat Posts: 1,455, Reputation: 132
    Ultra Member
     
    #2

    Feb 22, 2007, 09:20 PM
    Blower wheel could be going bad.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Forced air gas furnace fan auto or always on? [ 2 Answers ]

Is it better to leave the fan set to auto or always on, especially during extreme cold conditions when furnace is kicking on much more often? The furnace is 3 years old.

Gas Furnace Fan won't work [ 4 Answers ]

My American Standard furnace fan won't turn on. It will ignite, when it gets to the blowing stage it will turn off. All breakers check out fine. Can't find any other on/off switch inside unit. A burnt smell comes from vents, the same smell of when you first turn of the heater for the first time...

Comfortmaker Furnace Fan blows in line fuse and will not allow furnace to work [ 1 Answers ]

I have a Comfortmaker Furnace (approximately 1998/99) and the fan will not turn on allow the furnace to heat. When I try to turn the furnace on it blows a 3 amp fuse at the blower motor. I removed the fuse and jumped it and all it will do is make a faint buzzing noise and not turn on. I can...

GMC Gas Furnace Fan Won't Run [ 3 Answers ]

Hi, I have a friend with a GMC gas furnace that will not start. We are receiving a three blinking LED code that says pressure switch failed to close. We found this switch on the main air fan and discovered the fan will not run in auto or manual. We checked for 120 VAC output on the circuit board...

Gas furnace fan turns on but nothing comes out [ 1 Answers ]

When I turn on my gas furnace, the pilot light comes on, but goes off afer a couple of minutes after having produced nothing. When I turn on the manual fan, it starts up, but no air comes out. Any ideas? Thanks


View more questions Search