 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
Check out some similar questions!
I've disabeled all the safety switches, the engine turns over fine and I've isolated the ignition armateur (unplugged the ground wire from it.) the old one had spark on one lead but not the other so I figured it was bad. It ran sometimes but other times it would not start. Now that I bought a...
I have a MTD rider mower, I used it a few weeks back. Mowed for 30-45 minutes. Ran out of gas, put gas in it hasn't run since. Checked to make sure it is getting gas that's not the problem. Cleaned the spark plug (had fouled) but couldn't get any spark. Pulled the cover off the engine took sand...
I have a briggs and stratton 12.5 it turns over but has no spark I started it the day before and started first key but now it won't start any ideas
Crap that may be! How do I tell if the coil is good? I put an ohm meter across the spark leads. I think it said 4 ohms? I'm bidding on a manual for it on eBay. How do I do the gap. I pretty much just unbolted it and bolted the new one in it's place. I did put a connection on the otherwise bare...
Hi I have a question about my tractor. The engine is a B&S 16 hp twin cylinder model 402707. It was running great when it began to loose power. I checked the plugs and checked for spark. Very week and intermitent. Also one side better than the other. I bought and installed a new coil and spark...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
