Ask Experts Questions for FREE Help !
Ask
    jpjohns1957's Avatar
    jpjohns1957 Posts: 1, Reputation: 1
    New Member
     
    #1

    Mar 15, 2012, 05:54 AM
    AC not working properly
    When I set my thermostat on cool, my outside ac unit won't kick on if I set the thermostat past 73 degrees. It cools the house to 73, kicks off, then kicks back on when the inside temperature in the house goes over 73... so its kind of working but only at 73 or under... it worked normally before where I could set it at 77 degrees and it would go on & off.
    smoothy's Avatar
    smoothy Posts: 25,490, Reputation: 2853
    Uber Member
     
    #2

    Mar 15, 2012, 06:02 AM
    Sounds like a defective thermostat to me most likely.
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
     
    #3

    Mar 15, 2012, 05:35 PM
    Get a good thermometer, and see what the actuall temp in the house is, right next to the actuall thermostat. Your stat may be out of calibration, in which case, a new stat is most likely the answer, as smoothy suggested. If the actuall temp of the home is below 77, then it won't kick on till it gets hotter than 77 in the home. And if the stat is out of calibration, it may be off by several degrees.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Radiators not working properly [ 7 Answers ]

I hope someone can please help. We have had problems with our heating system (2 years old) for the past 2 months and have had the people who installed it working to repair it. First the boiler stopped working properly. After a new pump, heat exchanger and circuit board were fitted, the boiler...

Heater working properly? [ 2 Answers ]

I have a 14 month old so my heater is set at 70. Sometimes it does not kick on until the thermostat reads 68 and takes a while to heat the house. I have a 1900 square foot house. Also, some rooms seem colder than others. Is that normal?

Furnace not working properly [ 5 Answers ]

I have a Goodman furnace, model #GMH80703ANAB, it is about 2 years old. It tries to turn on, but then stops. Occasionally it will turn on and begin to ignite the electric ignition, but then will turn off before blowing out any heat. To my knowledge there hasn't been any water damage to it. I have...

Radiators not working properly. [ 1 Answers ]

Some of my radiators are not working properly. I tried bleediing them a few of them started to warm up but I still do not hear the water coming through them. I wanted to know if there was something else I can do in order to get them working. It's cold here in Pittsburgh, PA

Is thermostat working properly? [ 3 Answers ]

During the cycling of a furnace, how long should it be off and how long should it run? Thanks,


View more questions Search