Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Bathroom plumbing leaks
[ 1 Answers ]
I installed two sinks where I previously had one. I piped them both through their own p-trap and then into a T joint and into the wall. I have a leak on both drains here the p-trap comes up and connects to the pipe that goes to the T-Joint. The piece that is leaking has a flange molded into the...
Reconfigure bathroom plumbing
[ 2 Answers ]
I am about to completely renovate my bathroom, and I want to create a better flow by moving the tub, toilet, and sink. How do I go about moving the plumbing to make my bathroom feel less blotchy and more cohesive.:confused:
Bathroom plumbing
[ 2 Answers ]
I'm doing some renovations in a home built in the mid 50's. The waste lines are all cast iron. The toilet flange needs to be replace so I have decided to change all waste lines to PVC. The toilet has a 4" bend with a 2" connection for the tub drain. The line drops below the floor about 6" to 8",...
Basement bathroom plumbing
[ 2 Answers ]
Hi, Could someone please tell me whether my basement bathroom drainage is properly vented? Note that I am not concerned about building to code, I just want it to work. If you are interested in answering this question, I'll email you the drawing, because this forum will not accept an upload of...
Bathroom Plumbing/Venting Question
[ 2 Answers ]
Hi, I am doing a bathroom remodel and moving the location of the fixtures to make more use of the limited space. The question is, will the room be vented properly based on the drawing I have submitted. I would really rather not have to run a new vent here. Thanks a lot for your help. View more questions Search
|