 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
If the Check Engine Light consistently comes on for 2 seconds and then goes out, when the ignition switch is turned to ON (Position II), then the problem is with the distributor. Over 50% of new aftermarket distributors for Hondas don't work at AMHD--most of the remaining ones are problematic and unreliable. I only recommend install a genuine Honda distributor housing, where it's fine to install an aftermarket igniter and coil to keep the cost down.
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
It cracks but won't turn over. The spark plugs r good. Has new head cold air intake an twin cams. Has ran in a year. I have use a feeler gauge to gauge intake an exast. I have set cams an injecters. An has new battery but it won't start what could it be.
Can a 1993 honda integra 1.8 motor and 5 speed transmission go in a 1994 honda prelude with a 2.0 and automatic transmission
I have 92 Honda prelude, the ac ii sometime on for a while then the compressor clutch is disenge then working again. I checked the freon is OK around 35psi, pulled and checked clutch Relay?? It looks OK and ran fine for 8 hrs then clutch disengage and I have to turn off AC switch then back on and...
How do you set the timing on a 1990 Honda Prelude 2.0?
Hey I hope there is someone out there that can help me out I am in some real bad shape. I was in the process of installing a new O2 sensor in my 1991 Honda Prelude 2.0 SI. I had to cut the wires on the old one to get it removed. When I had the new one put in I was going to connect the wire...
View more questions Search
|
