I have and old General ontrol Furnace Valve that doesn't work.

jimlaw Posts: 3, Reputation: 1

New Member

Feb 27, 2012, 02:52 PM

I have and old General ontrol Furnace Valve that doesn't work.

I have a General Control 24 Volt valve model 5-50 . I have replaced the thermocouple and the valve still doesn't open. I suspect the coil is faulty. Is there a replacement for this valve or can the coil be rebuilt? It has a standing pilot.

Check out some similar questions!

General controls gas valve? [ 2 Answers ]

I have a General Controls B60Y64A123 Gas Valve on my Gas Furnace. I am replacing the Thermpile, but I am not sure what the Alum. Tube coming out of the gas valve and positioned next to the pilot is for. Please explain and does the end of the tube go in the flame or close to the flame. My gas valve...

Can this old General Controls millivolt gas valve be replaced? [ 3 Answers ]

I have an old General Controls millivolt gas valve: Https://picasaweb.google.com/112652995081934659158/GardenHeating#5515080849589233618 The valve is starting to operate erratically (sometimes does not come on until I tap it). Can someone recommend a replacement? Thanks.

I'd like to install a ball valve on main water line will a "Viperlok" valve work? [ 1 Answers ]

I know sweat soldering a ball valve is best, but will a "push-ft" compression "Viperlok" brand ball valve work?---My pipes are old copper, and have a few minor scratches and pits---I also noticed a seam running down one side of pipe. This water line runs out into garden, but valve is in the house....

Furnace won't turn on. Thermostat and zone valve work fine. [ 4 Answers ]

I noticed that my thermostat works fine and opens the zone valve for the basement. The problem is that it won't send a signal to the furnace to turn on and heat the water. I have no problem with the upstairs zone valve. It opens and turns on the furnace. Is this a wiring issue? Thanks...

View more questions Search

Check out some similar questions!

Add your answer here.