Ask Experts Questions for FREE Help !
Ask
    jaymiller377's Avatar
    jaymiller377 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Feb 27, 2012, 06:04 AM
    Heil 7000 breaker trip
    Brilliant 7000 pilot and blower fan starts. When circulating fan goes to start it trips breaker every time. What's wrong
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
    		  
    #2

    Feb 27, 2012, 07:53 AM
    Possible short in wires to motor. If you have a amp. Probe you can check amps to motor on start up, the info tag on the furnace should tell how many amps it should pull,, if to many motor is bad and needs to be replaced
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
    		  
    #3

    Feb 28, 2012, 10:51 AM
    The short in the wires going to the motor doesn`t happen very often
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

7000 Heil Furnace [ 1 Answers ]

My Heil 7000 furnace, installed new in 1993, is leaving a wet spot on the floor just below the lower right panel edge. When I slide my finger along this lower right edge, there is accumulated water, which is dripping ever so slowly, causing the wet spot. What might be the cause of this never before...

HEIL 7000 Part numbers [ 0 Answers ]

I am trying to locate the part number guide to a HEIL 7000 Natural Gas Furnace NUGK075DG08. I have a cracked housing on my secondary heat exchanger and would like to order a replacement. Thanks

Troubleshooting heil 7000 gas furnace [ 1 Answers ]

On initial start up on my Heil 7000 furnace it is making one heck of a noise until the blower comes on at which time everything is normal. Heater is working perfectly at that point. Do you have any ideas?

Heil 7000 [ 3 Answers ]

We have a Heil 7000 propane furnace. We had it installed in 1993 and haven't used it much over the years. This year when we started using it the motor had froze up and we replaced that part. Draft/flue inducer. I think is what it was called.Anyway after we reinstalled the part now the ignitors...

Burner - Fan sequence - HEIL 7000 [ 3 Answers ]

This is regarding a 12 year old HEIL 7000 furnace. When the house thermostat calls for heat, the induction exhaust fan kicks in and in a few seconds the pilot and burners are activated (all appear normal). Prior to the activation of the circulating fan, however, the high temp switch...

View more questions Search