Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Best way to cap a copper water line: compression fitting or copper cap?
[ 29 Answers ]
Hi all, Unsuccessfully tried to cap a copper water line by soldering a pre-soldered cap onto the end. Took all the proper steps, cleaned the ends of the pipe and fitting first, then applied flux around both. Wasn't quite sure what I should be heating, so I just heated everything. After my first...
Replaced a hot water tank,water is not going to the pressure tank-the pump stays on
[ 2 Answers ]
Replaced a hot water tank, turned the pump on and the water is bypassing the pressure tank. The pressure tank will not fill up and the pump remains on and will not shut off. We do get water though but needs to shut off the pump so it will not burn out. Any thoughts? Thank you Any ideas will...
How to drain water tank for Aqua flow water tank
[ 0 Answers ]
Have a lot of rusty residue in water tank in Aqua Flow water pressure tank. What is the procedure for draining and cleaning
01 celica overheating already change the reservoir tank and radiator cap
[ 2 Answers ]
01 celica overheating already change the reservoir tank and radiator cap but when I open the radiotor cap I little to let the pressure out it goes back to normal for 2 to 3 miles before. I have to do the same procedure again
Water pressure against tank height and tank water capacity
[ 5 Answers ]
Normally the head pressure of water is .433 pounds per foot of head. Is there any change in pressure by changing the tank water capacity. e.g. if two tanks of 50ft height having water capacity of one is 10,000 gallons and other one has 20,000 gallons. What will be the water pressure difference... View more questions Search
|