Ask Experts Questions for FREE Help !
Ask
    schristenson's Avatar
    schristenson Posts: 1, Reputation: 1
    New Member
     
    #1

    Feb 14, 2012, 07:25 PM
    Well pump wiring
    Can u tell me the functions of the red, black and yellow wires? I have changed the control box but do not know where the ground should go.
    hkstroud's Avatar
    hkstroud Posts: 11,929, Reputation: 899
    Home Improvement & Construction Expert
     
    #2

    Feb 16, 2012, 06:55 AM
    There are 2-wire and 3-wire well pumps. Apparently you have a 3-wire pump. The 2-wire pumps have a starting relay build into the pump. The 3-wire pumps are capacitor start motors and have a capacitor and starting relay in the control box. The yellow would be the neutral, (or common if 240) red and black would be the start and run circuits.
    Does the well wire have a ground wire? I believe most present day well wire has a ground. I don't believe that has all ways been the case. If your well wire cable has a ground connect your ground to it and the box. If you have no ground wire in the well cable, which is probably the case or you wouldn't be asking the question, just connect the ground to the box.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Pump wiring [ 2 Answers ]

Instructions state prepare a three core electrical set with plug. Okay Loosen the two copper screws marked with "V1 W1 & U1 and fasten the electric Power leads to them. But which one is hot(Black) and which one is Neutral(white) or does it matter. I know where the terminal for the green...

Pump Wiring [ 2 Answers ]

How do you wire a Pentair 110V/220V 1HP pump to 110V? The diagram indicates connecting to BROWN at the top and L2. There is a brown wire on the bottom but no screw to connect to. The top wire is WHITE but again no screw to connect to. There are only two screws to connect to and they are labeled...

Wiring for heat pump [ 1 Answers ]

How do I wire a heat pum thermostat

Heat pump wiring [ 1 Answers ]

I have a heatpump and gas furnace and wirinmg up a new thermastat honeywell visionpro8000 and will not turn the heat pump on possible wiring wrong? Colors are y-g-r-w-b and the heat pump wires are y-w-r-b-o The thermastat has on it y2-l-e-aux-s1-s2- left side heat pump and right side Heatpump...


View more questions Search