Ask Experts Questions for FREE Help !
Ask
    DanS1's Avatar
    DanS1 Posts: 1, Reputation: 1
    New Member
     
    #1

    Feb 5, 2012, 09:42 AM
    I took foam out of 5hp briggs gas tank and now it runs rich
    After removing foam from gas tank engine runs too rick
    DG's Avatar
    DG Posts: 1,375, Reputation: 109
    Ultra Member
     
    #2

    Feb 9, 2012, 05:37 PM
    I remove those all the time , that's not the problem , check the diaphragm between the tank and the carb.
    Luck

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

6.5hp Briggs and Stratton will not start. I have spark and gas but no compression. [ 6 Answers ]

This engine has a compression release and I think it is stuck open. I am not familiar with the release mechanism, a separate valve? Any help appreciated.

Briggs and Stratton 23 hp V-twin runs out of gas? [ 2 Answers ]

The engine dies after running the mower for 30 - 45 minutes. I have replaced the fuel cap with an original one, fuel line, air filter, fuel filter, fuel pump and hose that leads to the fuel pump form the valve cover. It just plain runs out of fuel because you can see inside of the fuel filter. ...

22hp briggs cuts off/runs out of gas when hot [ 3 Answers ]

The mower slows down and runs out of gas when it gets hot at times. Let it set for a few minutes to cool off and it will start back. Gas filter is empty when it cuts off, and will fill back by itself when it sets for 10 to 15 min. any suggestions! Thanks

5hp Briggs and Stratton runs rich [ 3 Answers ]

I've got a 5hp Briggs and Stratton Rototiller engine with a Pulsa-jet carb. This particular Pulsa-jet does not have the check valves in the pick-up tubes. Not required. All the parts are clean, the screens are clean, there is fuel in the constant supply cup. The needle valve isn't damaged and the...

5 hp briggs only runs when you pour gas in carb [ 1 Answers ]

I got a briggs motor somewhere between 5 and 6 hp. When I put a little gas in the carburater it sucks it in and then will start after a few pulls for about 30 seconds but when it runs out of the gas I pour in it dies then won't star. IF I give it half to full throtle it revs but it won't idle by...


View more questions Search