Ask Experts Questions for FREE Help !
Ask
    lonesomeinal's Avatar
    lonesomeinal Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Feb 1, 2012, 09:45 PM
    Failed commode water supply metal tubing
    Commmode water level low. Tank will not fill properly. I can close shut-off valve and then open valve and tank will fill quickly. If I flush commode tank will not fill properly until I close and re-open floor shut-off valve. I think the metal braided supply pipe has collapsed internally and not allowing water flow.
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
    		  
    #2

    Feb 2, 2012, 06:08 AM
    Hi lonesoimeinal and Welcome to The Plumbing Page. At AskMeHelpDesk.com.
    Which ballcock is yours. Back to you, Tom
    Attached Images
     
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Correct washer for metal flanged toilet "water supply line"? [ 6 Answers ]

I am installing a Fluidmaster Fill valve.. I have a metal flanged water supply line. Instructions say to use the existing coupling nut (have to.. Can't get it off anyway) and the existing washer. If this existing washer is a flat washer that sits on top of the flange, there wasn't one when I...

Copper tubing from water supply broke off [ 1 Answers ]

Copper tubing from water supply broke off... how do I reconnect ?

Fitting vinyl tubing over metal tubing [ 22 Answers ]

Please help me! I am looking for any and all advice on how to create a clear, rubbery coating of roughly 1/4" thick, around a 38" long piece of curved 1.5"OD aluminum tubing. The coating needs to be firm holding, and not slip at all; nor can it be clouded with glue or something. Nice and clear is...

Plastic supply line / metal shutoff valve [ 2 Answers ]

Dishwasher water supply line has leak where it enters the metal shutoff valve (at the back side of the metal nut - around the plastic line). Does this nut work with a compression sleeve and may need a twist with a wrench or are these plastic pipe to metal valve joints A permanent creation that I...

Pex tubing and water supply [ 6 Answers ]

Hi. I am building a new house, slab on grade. I am trying doing a lot of the work myself. I want to install the water lines under the concrete. What I am wondering is: with pex tubing, can I run a line to (example)one faucet, T in a connector, (above grade) and continue on, back under the slab,to...

View more questions Search