Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
1991 Volvo 740 vacuum problem
[ 5 Answers ]
I have a 1991 Volvo 740 2.3 non-turbo that is missing a major vacuum line. It starts the intake manifold and then runs up towards the master cylinder on the firewall. From that point, it "T's" off, with the bottom part of the line going up under the firewall. What I am missing is the other part...
Where can I find a picture of a 1987 volvo 740 model undercarriage
[ 2 Answers ]
I have a 1987 volvo wagon 740 model. I need to find a picture of its undercarriage so that I can determine what the long metal tube like piece is that has a hole in it that is leaking water.
My briggs has a little mss at high idle and lopes bad at low idle?
[ 1 Answers ]
I have a 14hp briggs on a 2004 toro 1438z ztr mower. It has a nikki carb which I rebuilt 2 days ago. When I start it it runs OK at high idle though it misses some, but when I idle it all the way down it lopes badly and occasioaly backfires. Is this a fuel solenoid problem or what??
High idle
[ 1 Answers ]
I have a 1989 chevy blazer with a 5.7 liter. I have changed temp sensor and throttle position sensor, but still have high idle. Wondering what else to check to remedy problem?
High Idle
[ 1 Answers ]
I have a 94 Grand Am 3.1 liter engine that while in park idles at about 2500 RPM and when you put it in gear may go down to about 1500RPM. After warming up a bit it might drop to about 2000 RPM. Didn't see any obvious problems. View more questions Search
|