Ask Experts Questions for FREE Help !
Ask
    jdharper's Avatar
    jdharper Posts: 10, Reputation: 1
    New Member
    		  
    #1

    Jan 22, 2012, 07:45 AM
    Goodman system has code 5 fan turns on every 10 minutes
    System works fine oyher than fan running when it wants to
    SeattlePioneer's Avatar
    SeattlePioneer Posts: 97, Reputation: 9
    Junior Member
    		  
    #2

    Jan 22, 2012, 10:14 AM
    Take the cover off the burner compartment of the furnace. Obtain the make and model of the furnace off the rating plate in the burner compartment and post it here.

    Observe the sequence of events that occurs at the furnace when you turn up the thermostat and post that sequence of events in order and in detail.

    Also, look for a sticker that deswcribes what the diagnostic codes indicate. Often it's on the inside of the fan compartment door.

    What you've posted is too vague to be of help.
    jdharper's Avatar
    jdharper Posts: 10, Reputation: 1
    New Member
    		  
    #3

    Jan 22, 2012, 11:29 AM
    Goodman gmp125-4 false flame
    SeattlePioneer's Avatar
    SeattlePioneer Posts: 97, Reputation: 9
    Junior Member
    		  
    #4

    Jan 22, 2012, 12:37 PM
    Your replies are WAY TOO VAGUE to be of any help to you.

    You must follow the following directions if you want some help:

    Observe the sequence of events that occurs at the furnace when you turn up the thermostat and post that sequence of events in order and in detail.
    SeattlePioneer's Avatar
    SeattlePioneer Posts: 97, Reputation: 9
    Junior Member
    		  
    #5

    Jan 22, 2012, 12:40 PM
    Also, the Goodman GMP furnace manual does not list any diagnostic codes.

    "false flame" is too vague to help identify what might be happening with any confidence.

    Is there any additional information given with this code? If so, post it.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Goodman Furnace turns on and immediately turns off [ 0 Answers ]

My 80% goodman furnace is 2 years old. I bought one for myself and my tenant. They do the same thing. They will kick on, but before the blower starts or the igniter lights, it kicks right back off. Once again, it will turn on and almost within 2 seconds, it turns off and will continually...

Goodman gmn080 ac fan runs then turns off [ 1 Answers ]

My goodman furnace works fine at all options. Ac works then turns off. Fan will not run at all. Replaced wire connectors on circuit board and all worked fine, then same issue, ran for couple days, then did not run. Light on the board is on with no blinking code indicating any problem. Seems to...

Furnace turns itself off every 2 minutes [ 0 Answers ]

HI, I have a furnace that won't stay in. The blower keeps blowing, but the heat cuts out because the flames get shut off every two minutes or so. Over the summer, we remodeled and streamlined the duct work. We eliminated lots of big runs that absorbed all the heat. Now, though, I think we...

Well water turns off every few minutes [ 3 Answers ]

Hello, I have a problem with water pressure on my home well. It is a standard well. I will try to explain problem. When you turn on water from any outlet it will run for about a minute and then completely turn off for about 10 sec. It then comes back on and repeats the cycle after a few...

Gas Heater Turns and Off every two minutes [ 1 Answers ]

Hello Our Gas Heater turns on and then after a short burst stops. I observed that the Gas flames start and stop every two minutes even though temperature that I set on thermostat has not been reached. Is this normal? Over the long run house heats up to the my require heat but I suspect this...

View more questions Search