Ask Experts Questions for FREE Help !
Ask
    Pasko01's Avatar
    Pasko01 Posts: 1, Reputation: 1
    New Member
     
    #1

    Jan 18, 2012, 12:52 AM
    Trane XR80 ignition problem
    I have replaced old furnace with new Trane XR80 6 years ago. Since then, I have to admit, I didn't spend too much time on maintenance, except I was replacing filters regularly. Occasionally, it would happened once or twice a month that ignition or burning would stop for moment and we would smell gas but it would turn back again and continue without any problem. However, this morning, ignition came on for couple seconds and turned off, while fan continued to blow. The error flush code (9 flashes) indicates: 'Check Ignitor Circuit and Line “N” to 24VAC”Common” voltage'. Looking through the schematic diagram I could locate Line and but no 24 VAC. In addition, even if find it, I have trouble locating on the furnace. And, even if find it, what 'Check Ignitor' means. To replace it? To clean it? BTW, it is snowing outside. :-)

Check out some similar questions!

Trane xr80 [ 0 Answers ]

I have a trane xr80 the lite is off. My ac is not working either. Could it be a fuse on the outside? I took the fuse from the house to ace hardware and they tested it. It is okay. What do I look for on the outside?

Trane xr80 troubleshooting [ 2 Answers ]

My xr80 furnace, when the fan is in the auto position, will not stay lit. it flames up for ten to fifty seconds but will not stay lit. when I turn the fan to the on position, it flames up and stays lit. I cleaned the furnace and filter. What could it be? What else can I do?

Trane xr80 [ 1 Answers ]

I have a Trane xr80 that's about 5 yrs. Old. Everything starts (pr-fan-burner-ect.) but the blower never kicks on. I need help troubleshooting the blower circuits.

TRane xr80 issues [ 4 Answers ]

My Trane XR80 furnace is only blowing cold air. The diagnostic light is bllinking 4 times. I checked diagnostic codes and this one means (open limit device). Please clarify which part(device) needs to be replaced?

Trane XR80 furnace intermittent problem [ 4 Answers ]

I have a Trane XR80 furnace. The furnace works fine sometimes, and other times is will not light. I get no error on the LED indicator on the main board. The ignitor gets hot but the furnace will not light. It appears that there is no gas getting to the burners. Any suggestions would be greatly...


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.