Ask Experts Questions for FREE Help !
Ask
    farmerken's Avatar
    farmerken Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 16, 2012, 03:26 AM
    Have lombardini powered lincoln weldanpower 225.
    Both aux & welding output is extremely weak,possible causes?
    corym's Avatar
    corym Posts: 1, Reputation: 1
    New Member
    		  
    #2

    Feb 14, 2012, 04:12 PM
    It sounds like there is a problem with the brushes or slip collars. They are located under the cover on the main shaft directly in front of the engine.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Early 1990's Lincoln Weldanpower 225 [ 16 Answers ]

I'm about to purchase a used Weldanpower 225. It was the model prior to the Lincoln Ranger 8 and is powered by a single cylinder 16 hp Briggs and Stratton gasoline engine. Does anyone know anything about this particular model welder... the goods... the bads... etc. Should I buy it or shy away...

Lincoln Weldanpower G8000 [ 2 Answers ]

My buddy gave me an old G8000 and under the cover I have three wires that I don't know where they go , all three come out of the altenater , two short fat ones and a long thinner one with a open end loop term. the others have eye term. the two short ones look like they might ground to the reactor...

Late 1980s lincoln weldanpower code#8928 [ 1 Answers ]

I am looking for a rotor (armature) for this machine which I picked up at an auction. The engine runs good but I am not able too get any voltage from the output terminals, Checked armature with meg meter it checked out bad.If I am unable to find an armature Machine will be sold for parts.

Lincoln Weldanpower WP 225G7 [ 2 Answers ]

I have a Lincoln Weldanpower Model: WP225G7, Code:9317, Serial #:A1128723. I don't use it too often but when I need it, I need it. It has some rust in the gas tank that keeps stopping up the filter. Lately I spend more time changing the filter than I do welding. I have drained the gas tank and...

Lincoln Weldanpower 225 [ 1 Answers ]

I recently purchased a Lincoln Weldanpower 225 and the current transformer is bad. I would like to purchase another one with a bad motor that I could use for parts. If anyone knows of one. Thanks

View more questions Search