Check out some similar questions!
John Deere 112L dies when blade is lowered
[ 0 Answers ]
Just bought an old 112L - If I prime the carb and jump the battery the engine will start and run. It seems I can drive it around without issue but when I engage the PTO and lower the blade it dies and drains battery. If I raise the blade before it dies it seems to pick up power and cont. running...
John Deere 316 cranks but shuts off when put in gear
[ 1 Answers ]
When I start my John Deere 316 it cranks fine, but when I put it in gear it shuts off. Does the same thing when I try to engage blades. Thanks!
John Deere 316 dies when hydro engaged
[ 2 Answers ]
I have a 1986 John Deere Model 316 riding tractor. I have a problem with a safety switch somewhere that I cannot seem to locate. When I start the motor and try to engage the hydrostat or the pto, it dies. I have replaced the switch on the hydro control and cut the wires on the seat switch and...
John deere mower dies after it's warmed up
[ 2 Answers ]
My 255 John Deere mower dies after I've been mowing about ten minutes and has no fire at all. After it has completely cooled off it starts right up but will just die again after it has gotten warmed up. Is this possibly the electronic ignition going out? When it dies I've held plug wire and ground...
John Deere L110 Starts Will Not Move
[ 2 Answers ]
My L110 starts but will move neither forward or reverse. I've check the free-wheeling gear (OK) and the brake lock (OK). Still will not start. I was attempting to drive up a steep incline (about 20% grade) with a flat rear tire. After spinning for a while, I shut it down. Now after replacing the... View more questions Search
Add your answer here.
|