 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Powerstroke 6.0 not starting.
I bought a 2004 6.0 diesel not running, the previous owner said it was running but stopped. I replaced the Injectors, replaced the hi-pressure oil pump, changed the IPR & the ICP, bleed the oil rail, still not starting. Not even a hint of starting. What else can I do?
I have not tried the computer, Can I remove the computer from the vehicle & get it checked out? |
||||
Check out some similar questions!
We just had our fuel filters changed on our 2007 Ford F250 Powerstroke. Since then twice it would start, but not stay started. I used the "heet" diesel drier in the tank, and it started up for me two days ago. Then today (on the same tank of gas) it did the same thing a couple times. Then about...
Can you take out a 6.0 in a 2003 F350 and put in a 6.0 out of a 2006 F450 will it work? Any modifications or changes? Is the bell housing the same?
It usually starts OK in the morning, but once its warmed up, it has a lot of problems continuing to start. Sometimes it starts, revs to idle, then dies again. After about ten minutes and a couple of tries, it starts right up and drives away fine. Any thoughts? We know we can't replace the fuel...
I have a 99 powerstroke that has trouble starting when warm. It runs fine after it starts. It will always start right away when its cold. My oil is up and I put in a new fuel filter,could it be my transfer pump.
Any time the truck has been setting long enough for it to cool off when I start it it runs rough and if I don't let it set and warm up it has very little power and it shutters if I try to accelerate to quickly. I had it in the shop a while back and had the injectors checked, I had one bad and...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
